VSP-V-1094A
Issue
7
V-1094A
PAGE PORT PREAMP/EXPANDER
INTRODUCTION
These instructions contain the specifications and
information necessary to install, operate and maintain
the V-1094A Page Port Preamp/Expander.
SPECIFICATIONS
Design
The Valcom V-1094A Page Port Preamp/ Expander is
a solid-state audio preamplifier. The unit comes with
its own surface mount box, which provides ½ inch
conduit access. The amplifier will accept a high
impedance input (600 Ohms) and reduce it to a low
impedance output. When the control knob is set on 5,
the input signal level equals the output signal level.
Frequency Response:
80Hz to 10kHz +/-
3dB
Gain (into 8 Ohm load):
+8dB maximum
The V-1094A is capable of driving 150 Valcom
one-way speaker/amplifier assemblies.
INSTALLATION
Applications
These instructions cover only the installation of the
Valcom V-1094A. Consult the practices of other
equipment if any other equipment is used.
•
To interface 600 Ohm type page ports to up to
150 Valcom amplified speakers
•
To expand the number of Valcom amplified
speakers on a zone by 150
Input
V-1094A
Page Port
Preamp
Expander
600 Ohm page port
or zone output of a
page control unit
Power Supply
Up to 150
One-Way
Amplified
Speakers
T
R
(J1)
(J3)
Output
T
R
(J2)
-24V GND
Input level equals output
level at position 5
Audio and Power Connections
•
To pre-amp audio signal on long lines to Valcom
amplified speakers
•
To provide master volume control convenience
to all or a portion of a paging zone
Dimensions/Weight
•
4.44"H x 2.75"W x 2.88"D
(11.28cm H x 6.99cm W x 7.32cm D)
•
0.9 lbs. (0.41 kg)
Power Requirements
Voltage Range:
-21 to -26VDC "B" Battery
Idle Current:
12mA
Operating Current:
15mA
Refer to the figure above for connections.
Cabling "D" type station wire or other suitable pairs
may be used for audio and power connections.
Nominal Specifications
Input Impedance:
600 Ohms
Output Impedance:
8 Ohms
1
947095
