TX05KSS/61D082B & TX05KSS/61S082
17
/ 20
User Manual
Rev. 1.0 - 28/10/16
6. Base Operations
6.1 Exciter (PTX DDS)
(PTX DDS)
•
Set the exciters following the instructions of the exciters that you are used to
set the desired operating frequency. Adjust the output power of exciter to the
power required to drive your transmitter.
Before that you enable the delivered power from exciter, it is suggested to
check and, in case, correct the basic parameters under own necessity:
•
frequency
•
power
•
audio input
Note:
Some information here contained may be not necessary for the proper
functioning of your transmitter.
•
To enable/disable the power supply, please read the instructions in the manual
of your exciter. It can be done tipically in the first seconds of switching on of
exciter (ie: for the PTX-DDS, after that a new window appearing accompanied
by an intermittent beep, when you press the encoder the exciter’s output power
will disable). In this way, you can change the working parameters before you
begin to transmit.
Note:
turning the encoder, the cursor moves itself on indicators of the various
sub-menus, while in the middle of the window it shows the contents. If you press
the encoder while the indicator of a menu is highlighted on navigation bar, and if
it contains adjustable parameters, the cursor moves within the central window of
the display, allowing you to act on adjustable parameters. Every menu contains a
“EXIT” field: by pressing the encoder while this field is highlighted, you will leave
the submenu and return to navigation mode.
•
To adjust the desired
working frequency
do the following operations:
Select the Admin/
MAIN
(RFset) menu, rotate the encoder and then press it
to enter in the submenu.
