PAGE 11
Attaching Squeegee
1. Lower the squeegee mounting plate by
depressing the squeegee switch
(A)
to the
down positio
n.
(See picture below)
2. Loosen the four knobs
(B)
on the
squeegee and slide them into the slots in the
squeegee mounting plate.
(See picture below)
3. Tighten the four knobs
(B)
and connect
vacuum hose
(C)
from the machine to the
squeegee.
(See picture below)
4. You may have to adjust the squeegee
pitch by turning the pitch adjustment knob
(D)
.
(See picture below)
5. Note vac exhaust, dual vac out
*assists in drying
(See picture above)
Removing Squeegee
1. With the squeegee in the down position, turn
key switch off & remove key.
2. Disconnect vacuum hose from squeegee and
loosen the (4) knobs.
3. Pull squeegee assembly rearward from the
lifting carrier.
4. Inspect or repair as necessary and reinstall.
Replacing or Rotate
Squeegee Blades
For safety
: before leaving or servicing the
machine, stop on a level surface, turn off
machine, and remove key.
1. Remove the squeegee assembly from the
machine.
2. Loosen latch
(E)
and swing both retaining
straps away from squeegee to remove the
rear squeegee blade.
(See picture at lower left)
3. To remove the front squeegee blade,
remove all the knobs
(F)
on the front of the
squeegee assembly, then remove the
retaining strap that secures the blade in place.
(See picture below)
4. Rotate the squeegee blades to new edge
position or replace as required.
5. Install blades on the locating pins of
squeegee assembly.
6. Reinstall squeegee retainer straps.
7. Retighten front knobs & rear latch.
A
D
B
C
E
F
