PAGE 10
Machine Setup
Uncrating Machine and
Connecting Batteries
1. Carefully check the crate for any signs of
damage. Batteries are in the unit.
2. To uncrate the machine, remove banding
from around the crate. Take off the top and
sides and dispose of properly.
3. Remove banding from machine. Remove
the chocks around the drive wheels.
4. Turn all switches to the off position and
remove key.
5. Tip back seat to expose the battery
compartment and check to see that the
battery cables are connected.
A standard machine is equipped with (6) 6-volt,
deep cycle, 325 ah batteries, which form a 36
volt system. Maximum battery dimensions are
7-1/8"W x 12-1/4"L x 13-1/4"H.
6. Verify that all of the battery cables are
connected to the batteries tightly. Locate any
loose ones and connect to the open terminal.
Tighten with 9/16" wrench.
(DO NOT OVER
TIGHTEN!) Batteries are heavy but easily
damaged.
Put covers in place. (See picture to
the left)
7. Turn on main power switch and check the
battery condition meter to ensure correct
installation.
8. Fold down ramp, and drive machine off of
the base.
Notify the carrier immediately if concealed
damage is discovered.
