Version 02.10.2019
HW CAM(V98)/(V12)
RL4-R40-E
P
a
g
e
10
2.4.
Connection – 20pin PNP harness
Connect the female 10pin connector of the 20pin PNP harness cable to the
10pin Power / CAN connector of the video interface.
Disconnect the female 20pin connector of the factory harness at the rear-side of the
head-unit and connect it to the male 20pin connector of the 20pin PNP harness.
Connect the opposite female 20pin connector of the 20pin PNP harness to the
previously become free male 20pin connector at the rear-side of the head unit.
Note: If, after connecting the 10pin Power / CAN cable, no interface LED lightens up while
the ignition is turned on, refer to chapter “Analogue power supply for the video interface”.
Please carry out the following checks:
