R.L.W. McCabe Lumber Co. Slatyfork Sawmill Interior, Руководство пользователя

Страница: 5 / 28

5
RLW RLW
RLW RLW
RLW
Transfer
The four short transfer frames (A.1) glue into
the four leftmost slots in five of the long
bases (A.3) with the bases fitting into the
notches on the bottom of the frames.
Glue the six long transfer frames
(A.2) into the rightmost slots of the
long bases, and glue the four short
bases (A.4) into the notches on the
extension of the long transfer frames.
Glue the sixth long base (A.3) under
the upper section of
the frames.
The chain well
floors (B.9-B.11)
glue into the
transfer frames as
shown in the
drawing and photo
below. Paint the
grooved pulleys
with Grimy Black
and glue 15 of them
into the notches on
the tops of the
transfer frames.
Glue the side rails (B.6-B.8) to the top of
the transfer frames as indicated in the
drawing and photo on page 6 after sanding
an angle on the mating ends to provide a
smooth joint. Glue the decks (B.1-B.5) to
the top of the transfer frames as shown in
the drawing and photo on page 6 after
sanding an angle on the mating ends to
provide a smooth joint. The edges of the
upper and lower decks will need to be
sanded where indicated to give a snug fit.
When dry, sand the outer edges of the rails
flush with the frames.
Place, do not yet glue, the transfer into
position on the sawmill floor (see the
drawing on page 25) and draw a line on
the outer short transfer frame at the level
of the main sawmill floor. This is the