Page 46
17.4 Assembly
Remove plastic bung 'A'. Remove screw 'B'.
Insert 3/4 inch diameter tube item 'C' over end of armrest tube. Line up holes in item 'C' with screw
hole in armrest tube. Insert screw 'B' and retighten.
Insert the tubular mounting stems complete with stem brackets supplied with the tray, into the
armrest stem assembly with the horizontal extensions of the mounting stems projecting forward.
Place the tray symmetrically on the stem brackets, ensuring that the flat plates are located
between the two guide strips on the under-side of the tray.
Mark through the screw holes in the stem brackets.
Remove the tray and brackets from the powerchair and secure brackets to tray with screws
supplied.
Refit tray assembly to the powerchair. Screw the two loose knurled knobs supplied with the tray
assembly, into nuts welded to the armrest stem assembly item 'C'.
Adjust tray position and tighten the four knobs.
