R.E Prescott Bubble-Up Jr Interactive, Инструкция по установке и эксплуатации

Страница: 10 / 30

Bubble ‐ Up® Jr Interactive™ Radon Removal System
10
Important information about venting: Since the Bubble ‐ Up® Jr Interactive™ unit removes radon in the water; the unit
must be vented carefully. Common practice is to run the vent up past the roof line of the building. An elevated vent
opening provides the best way of dissipating the radon gas. Protocols recommend extending the vent opening 2’ above
the highest opening in the building, and at least 10’ away from the nearest opening. It is recommended to protect the
vent opening with a vent screen. A single free hard (printed) copy of the ASTM E ‐ 2121 standard (Recommended
Residential Radon Mitigation Standard of Practice) is available from EPA’s National Service Center for Environmental
Publications (NSCEP). You can order a copy by phone at 1 ‐ 800 ‐ 490 ‐ 9198, via E ‐ mail nscep@bps ‐ lmit.com, or via the
internet at www.epa.gov/nscep/ordering.htm Please use the EPA document number (402 ‐ K ‐ 03 ‐ 007) when ordering E ‐
2121. EPA reprints E ‐ 2121 under agreement with ASTM International.
17. Plumb the mechanical pump control and plug pump cord into low water piggy ‐ back float cord. Plug the low
water piggy ‐ back float cord into the female cord of pump control. See Figure 7.
18. Check all plumbing fittings to be sure all fittings are water tight.
19. The water alarm valve control is wired to the power supply, motorized ball valve, and water sensor terminal
block.
20. Install 9V battery backup into water alarm control.
21. Terminal block wires are connected to high water alarm valve control, water alarm float switch and water alarm
floor sensor. These wires are twisted together and connected to terminal block.
Note: Water Sensor Terminal Block Connection: Connect the water alarm float wire, water alarm control (figure 6), and
water alarm sensor wires to the terminal block (The terminal block is located next to the air vent, figure 7). Connect one
wire to the black connection of the terminal block and the other wire to the red connection of the terminal block. It is
very important that this is a good connection.
Figure 6 ‐ Installation Points
Air Water Coupling
Pump Access
Well Seal
Bubble ‐ Up Blower
2” Blower Attachment
Nipple
Mechanical Pump Control
Plug Blower and Solenoid
into the Duplex Outlet
Low Water Piggy ‐ Back
Float Cord and High
Water Alarm Float in
the cord seal