R.E Prescott Bubble-Up Jr Interactive, Инструкция по установке и эксплуатации

Страница: 26 / 30

Bubble ‐ Up® Jr Interactive™ Radon Removal System
26
TECHNICAL DATA
Flow Rate…………………………………...See Pressure flow chart below
Power source…………………………. 115 Volt AC, 60 Hz, single phase
HP rating …………………………………………..………………1.5 HP 115
volt
Operating Pressure Range…………………………………………. 0 – 75 PSI
Maximum Allowable Pressure………………………………………... 80 PSI
Maximum Liquid Temperature………………………………………… 100°F
Connection……………………. 1” SCD 80 union inlet, 1/2” PEX outlet
Protection Level…….………………UL Listed Pressure Switch & cords
C. INSTALLATION
1. Use only 115 volt outlet for the Bubble ‐ Up mechanical pump control.
2. The bottom 1” schedule 80 union and top ½” PEX fittings are to be water tight and secure.
3. Check that the pump is primed before plugging in the Bubble ‐ Up mechanical pump control.
4. The Bubble ‐ Up mechanical pump control is supplied with 115 volt electrical cords. Connect the pump’s male
power plug into the Bubble ‐ Up mechanical pump control female cord.
5. To start the pump, refer to OPERATION below.
6. The pressure switch factory set at to turn the pump on at 45 PSI. To set pressure switch for proper operation
see instructions above.
WARNING! Unplug the Bubble ‐ Up mechanical pump control before removing the pressure switch cover.
7. Always use the bladder tank provided with the Bubble Up. The correct pre ‐ charge air pressure in the tank is 40
psi.
D. OPERATION
See setting pressure switch above. The Bubble ‐ Up mechanical pump control starts the pump when the pressure drops
to 45 PSI. The pump will run constant when the flow is greater than ½ to 1 GPM. When water flow falls below ½ to 1
GPM, water fills the required cycle tank providing a minimum run time before the pump is shut off.
Internal parts include: 2 ‐ Check Valves,
a Nozzle and Throat Assembly with
retainer, Double Check Valve and
Nozzle Retainer and 3 screws.