QWICK KURB
®
, INC.
Long Term Installation Manual
SETTING THE L60 SEPARATOR UNITS INTO POSITION
SETTING THE L60 SEPARATOR UNITS
Verify that you have the required components to begin the L60 SEPARATOR installation
process.
IMPORTANT: Before beginning, inspect all the L60 SEPARATOR components. Never use a
damaged or irregular piece of any L60 SEPARATOR component.
DO NOT DRAG THE L60 SEPARATOR UNITS
Sliding the L60 SEPARATOR a few inches to correct alignment is acceptable. However,
under no circumstances are the L60 SEPARATOR units ever to be dragged along a hard
surface such as a road. If the L60 SEPARATOR units are inadvertently installed in an
incorrect location or must otherwise be relocated, you must take up the L60 SEPARATOR
units as instructed in the
Removal
section on page 25, and re-install them in the new
location. Alternatively, contact
QWICK KURB
®
, INC.
operations personnel for instructions.
Two critical components of the L60 SEPARATOR that can be damaged by dragging are the
steel connecting hooks and the raised feet. Dragging a long line of L60 SEPARATOR units
may bend the steel connecting hooks, endangering the connections.
Dragging may also wear down the raised feet, which is unacceptable. The raised feet raise
the L60 SEPARATOR slightly above the roadway surface to allow water run-off that is not
handled by water channels.
Phone: 800-324-8734
Fax: 813-645-4856
www.qwickkurb.com
1/21/2016
14
