Qwic PREMIUM SERIES, Руководство пользователя

Страница: 71 / 128

71
NEDERLANDS
ENGLISH
DEUT
SCH
General components of the bicycle
Hydraulic Disc brakes
Disc brakes combine high braking power with a high
level of control. The brake pads of the hydraulic disc
brakes can be adjusted by slightly loosening the Allen
bolts of the caliper mount. Center the caliper while
pulling the brake levers firmly. Tighten the screws firmly
when you are done adjusting.
Noise complaints when braking
Brakes can resonate while braking. When new braking
pads are installed, it is important to properly bed in
braking pads. This will reduce noise complaints and also
increase the durability of your pads greatly.
To bed in new braking pads, find a safe environment
and built up some speed (around 25 km/h). Now brake
a little bit for 5-6 seconds, just enough that the pads
are in contact with the rotor. Then pull the brake levers
more firmly and slow down to about 5 km/h. With
the brake levers still slightly pulled, speed up again to
25 km/h. Repeat 10-15 times to fully bed in the new
pads. Remember to not fully brake to standstill at once
without releasing the brake levers, this might cause
damage to the rotor. Bed in the front and rear pads
separately.
Belt drive
Gates CDX belt drive
The Premium MN380 has been equipped with a belt
drive. Belt drive is an excellent choice for high powered
mid-drive motors such as the Brose model. The belt
drive is surprisingly silent and almost maintenance free.
Belt drives do not need lubrication, which makes it a
lot cleaner than regular chain drive. For this reason the
Premium MN380 and MA8 are not equipped with a
chaincase. You can clean the belt with plain water.