WWW.DUALSIG.COM
30
(
Period
) Trigger the motion detect signal in the set time section. You can set
according to week or set uniformly. Each day is divided into four time sections.
means the setup is valid.
Picture 4.6 set the time section
(
Interval
) Only one alarm signal is turned on even if there are several motion
detection signals in the set interval.
(
Alarm output
) Starts the external equipment of the linked alarm when the motion
detect alarm is turned on.
(
Delay
) Delay a few moments and stop when the alarm state is turned off. The
range is 10~300 seconds.
(
Record channel
) Choose the recording channel (multiple options are supported).
Trigger the video signal when the alarm is turned on.
Note
: Set in the [recording setup] and perform the linked recording. Start detecting
video iles in the corresponding time section.
(
Tour
)
means that the selected channel is a single window alternate patrol
preview. The interval is set in the [MainMenu]>[System] > [Tour].
(
Snapshot
) Choose record channels, when the alarm activates, the system
triggers the related channels for a snapshot signal.
Note
: For snapshot activation, please go to set period, detect and alarm enable at
MainMenu->Record->Record conig,
(
PTZ Activation
) Set the PTZ activation when the alarm is turned on.
Note
: PTZ activation is set in the [shortcut menu] >[ PTZ control]. Set the patrol
between spots, trail patrol and so on.
Picture 4.8 PTZ Activation
(
Delay
) When alarm is over, recording will last a few seconds(10~300sec),then
stop.
(
Show message
) Pops the alarm information dialog box into the local host
computer screen.
WWW.DUALSIG.COM
