4. HANGING YOUR FAN
WARNING -
Turn off the power!
DO NOT fasten the blades to the fan until it is
assembled and hanging from the ceiling.
1.
If not already affixed to the hanger
bracket, place the rectangular rubber isolators
between the hanger bracket and outlet box.
Secure the hanger bracket to the outlet box
using the 2 long steel screws supplied with
the outlex box. (Fig. 5)
2.
Remove the set pin and safety lock clip
from the yoke on top of the motor assembly
(Fig. 6a). Slide the downrod through the
canopy and canopy cover. Slide the yoke
cover onto the downrod (Fig. 6b).
Feed the wires from the fan motor through
the downrod assembly.
3.
(Fig. 7) Attach the downrod assembly
(downrod, yoke cover and canopy) to the
motor by sliding the downrod into the yoke
on top of the motor assembly. Slide the
set pin through the hole in the yoke, downrod
and secure it with the safety lock clip. Tighten
the screws on the yoke. The yoke cover will
lower down to conceal the yoke. Feed
the wires through the downrod ball.
4.
Lift the fan motor without the blades and
place into the hanger bracket, rotating the
ball until the groove engages the tab on the
hanger bracket. This locks the ball mount
and fan motor, preventing fan rotation during
operation. (Fig. 8.)
Outlet box
(j-box)
Hanger bracket
Safety
Lock Clip
Motor
housing
Safety
Lock Clip
Set pin
Set pin
Set screw
Washer
Washer
Downrod
assembly
Downrod
assembly
Downrod
Yoke
Yoke cover
Yoke
cover
Washers
Outlet box
screw
Downrod
Hanger
bracket
Fig. 8
Fig. 5
Fig. 6a
Fig. 6b
Fig. 7
Ceiling
canopy
