3
2016 QuoizelInc.
Crossbar Assembly
Outlet Box Screw
Outlet Box
6” Rod
12” Rod
Fixture
Fixture Loop
Rod
STEP 1:
a. Secure the crossbar to the outlet box (not included) with
outlet box screws.
b. Tighten until snug.
: The preassembled mounting nipple on the
crossbar should protrude outward.
Note
STEP 3:
a. Choose desired hanging length for the light fixture.
Suggested mounting height over a table or island is 30
inches from the table/island top to the bottom of the
fixture.
b. Assemble the necessary rods using the 6 inch rod(s)
and/or 12 inch rod(s).
c. Pass supply wires and ground wires through the rod
assembly.
d. Attach the rod assembly to fixture.
e. Hand- tighten until snug.
- Assemble one rod at a time.
- Pass the ground wire through the rod first.
- Then, pass the supply wire through the rod.
- Thread the rod by hand until snug.
Suggested rod length to hang fixture 30 inches above
table top:
- 8 ft. ceiling (2) 12 inch rods + (2) 6 inch rods
- 9 ft. ceiling (4) 12 inch rods + (2) 6 inch rods
- 10 ft. ceiling (6) 12 inch rods + (2) 6 inch rods
: If mounting over an Island, subtract 6 inches
from the lengths listed above.
Note
STEP 2:
a. Remove lock ball and
from crossbar
assembly.
b. Fit ceiling canopy over the nipple on crossbar assembly
and secure with lock ball.
: The ceiling canopy should be snug against the
ceiling and the lock ball.
If not, adjust the length of the nipple on the crossbar
assembly by unscrewing the preassembled hex nut.
Then, screw the nipple in or out of the crossbar until
the desired length is achieved.
Once the ceiling canopy is secure, remove the lock ball
and ceiling canopy and proceed to Step 3.
Note
?
?
?
kunrled nut
lock ball
Kunrled Nut
Crossbar Assembly
Hex Nut and
Lock Washer
STEP 4:
a. Pass supply wires and ground wire through the fixture
loop.
b. Thread the fixture loops to the end of each rod.
c. Hand- tighten until snug.
12
4
