Section 13-Canopy Installation
Required Tools and Adhesive
•
Xacto knife, #11 blade
•
Drill and 1/8” drill bit
•
Thin/Medium C/A
•
Rat-tail file
•
Alcohol swab
There are two holes in the fuse, one
on each side, to accept the screws to
hold the canopy in place. There is
also an anti-rotation pin to hold the
canopy in place under vibration that
needs to be glued on.
Step 1
Find the locations for the two screw
holes. You can easily do this by
looking from inside the fuselage.
Step 2
Use your Xacto # 11 blade and
remove the Ultra-Cote.
Step 3
Now slip the canopy in place onto
the fuselage, mark and drill the holes
in the canopy plywood tabs for the
blind
You will install the nuts in the inside
of the tabs.
Figure 84
Step 4
Insert the blind nuts on the inside of
the canopy hold down tabs and
tighten the 3mm screws with the
Allen wrench provided to seat the
blind nuts firmly into the plywood tab.
Figure 85
Figure 86
You should run a little thin or
medium C/A around the blind nuts
35
Содержание Semi Scale Yak-54
Страница 34: ...Figure 82 Figure 83 34 ...
