7
1. Attach the high pressure hose (7) to
the trigger gun (8) and machine.
Detach the high pressure hose by
pressing the pawl (A) or button (B)
1.
Push
the
lance
(10)
into
the
trigger
gun
(8)
2.
When
inserted
turn
it.
Caution:
Make
sure
the
lance
(10)
is
properly
fixed
to
the
gun
(8)
3.
Attach
the
nozzles
(11).
Caution:
When
attaching
the
nozzle
(11)
the
button
(A)
on
the
nozzle
(11)
should
come
out
again.
Check
before
activating
the
trigger
that
the
nozzle
(11)
is
properly
fixed.
An ordinary 1/2" garden hose of min.
10 m and max. 25 m will be suitable.
IMPORTANT!
Only use water without
any impurities. If there is a risk of sand
particles in the inlet water (i.e. from
your own well), an additional filter
should be mounted.
1. Let the water run through the
water hose before connecting it to
the machine to prevent sand and
dirt from penetrating the machine.
Note: Check that the filter is fitted
in the water inlet pipe and that it is
not clogged up.
2. Connect the water hose to the
water supply by means of the quick
connector (inlet water, max.
pressure: 10 bar, max. temperature:
40°C).
3. Turn on the water.
The
trigger
gun
(8)
and
lance
(10)
is
affected
by
a
thrust
during
operation
-
therefore
always
hold
it
firmly
with
both
hands.
Plug the power cord into a grounded
120V outlet, that is on a dedicated
circuit. Do not use extension cord.
Press the reset button on the GFCI
plug adapter. This must be done each
time the unit is plugged into an
outlet.
Grounded plug/reset button
3.2 Mounting of high pressure hose
3.3 Mounting of lance and nozzle
3.4 Water connection
3.5 Start/stop of the machine
A
B
1
2
A
3
2
