Page 5
For technical questions, please call 1-888-866-5797.
Item 64915 64916
Measuring Torque
1. Use the M Button to select one of
the target torque ratings.
2. Use Up/Down Buttons to adjust target as desired.
3. Apply torque slowly and grasp the center
of the handle. Do not apply load to the
end of the handle or the display.
4. The current torque will be displayed.
Press the M Button to save the measurement.
will be displayed while the
Wrench saves the measurement.
Note:
If the display shows
instead, the Wrench
has no memory available to save new measurements.
Previously saved measurements need to be deleted
before new measurements can be saved.
5. When 90% of the target torque rating is reached,
the green indicator will light and
the Wrench will beep periodically.
6. When the target torque rating is reached,
the red indicator will light and
the Wrench will beep continuously.
Measuring Angles
1. Use the M Button to select one of the target angles.
2. Use Up/Down Buttons to adjust target as desired.
3. Press the Button.
will flash on the
display while the Wrench prepares to measure
an angle. Once the target angle appears again,
the wrench is ready to measure an angle.
Note:
If the target angle does not appear after several
seconds or
is displayed, angle preparation was
not able to complete. The Wrench may have been
moved or the anvil turned.
Rest the Wrench on a
stable surface and press the Button to try again.
4. Apply torque slowly and grasp the center
of the handle. Do not apply load to the
end of the handle or the display.
Note:
Angle will be measured when at least 5%
of maximum operation torque is reached.
5. The current angle will be displayed.
Press the M Button to save the measurement.
will be displayed while the
Wrench saves the measurement.
Note:
If the display shows
instead, the Wrench
has no memory available to save new measurements.
Previously saved measurements need to be deleted
before new measurements can be saved.
6. When 90% of the target angle is reached,
the green indicator will light and
the Wrench will beep periodically.
7. When the target angle is reached,
the red indicator will light and
the Wrench will beep continuously.
Note:
The display will alternate between current torque
and current angle when target angle has been reached.
