Page 4
For technical questions, please call 1-888-866-5797.
Item 64915 64916
Advanced Settings
1. Press and hold Fn Button until
appears, then release it.
2.
means Peak/Track setting.
3. Press Fn Button.
means Angle Torque Unit setting.
4. Press Fn Button. If there are saved torque
measurements
(cycling between
record number and recorded value) will
be displayed, otherwise
will be displayed.
This is the Saved Measurement Review mode.
5. Press Fn Button again to display
,
Measurement Clear mode. Press the
Button twice to clear the previously
displayed Saved Measurement.
6. Press Fn Button again to display
,
Communication Mode. This Mode
is not used on this Wrench.
7. Press Fn Button one last time to return
to normal measurement mode.
Setting Peak/Track
1. Follow instructions above to enter
setting.
2. Use Up/Down Buttons to toggle between
Track (T) and Peak (P) modes. The selected
mode is shown in the lower right of the display.
3. Press and hold Fn Button until
disappears.
Setting Angle Torque Unit
1. Follow instructions above to enter
setting.
2. Use Up/Down Buttons to change torque unit.
The selected unit is shown on the
right side of the display.
3. Press and hold Fn Button until
disappears.
Saved Measurement Review
1. Follow instructions above to enter
Saved Measurement Review mode.
2. If there are saved torque measurements
(cycling between record number
and recorded value) will be displayed,
otherwise
will be displayed.
3. Use Up/Down Buttons to select
a Saved Measurement.
4. Press Fn Button again to display
,
Measurement Clear mode.
To clear a saved measurement:
a. Press the Button.
b.
will be displayed to confirm deletion.
c. Press the Button again to confirm deletion
or press the Fn Button to cancel.
When a measurement is deleted
will be displayed briefly.
5. Press Fn Button again to display
,
and exit Saved Measurement mode.
