Quincy QGV-20, Инструкция по эксплуатации

Страница: 29 / 92

Section IV - Operating Procedures
The settings in the BLUE box apply to the
Continuous and AD modes only.
Auto-restart activates the power-on starting
of the compressor. This is to automatically
restart after a power interruption. If the
time is ‘0’, then this function is not active.
Make the time setting suffi ciently long to
allow power to be stable before starting.
NOTE: this will be active as soon as it is
made non-zero, and the compressor will
start.
If multiple compressors are installed, make
this value different on each, to stagger the
start-ups, to limit power draw.
The operating mode for this compressor is
selected by pressing the Operating Mode
button. The selection will toggle between
Continuous, Auto-Dual and Networked
modes of operation.
RUN MODES:
pressures that are 2 psi below;123 Unload
and 98 Load, and so forth.
The Network Run Mode is selected from
‘LIFO MODE’, or ‘AUTO-ROTATE Mode’.
LIFO MODE is Last In, First Out
sequencing, and is considered a normal
way of running.
AUTO ROTATE mode should be used
with compressors that are matched in
capacity, and will equalize the running
hours by shifting the sequence every time
the desired hours expire. If Auto-Rotate
was selected, then the rotation will be the
hours entered for that function.
The machine ID relates to this compressor,
and identifi es it’s position in the Operating
Sequence.
The Operating Sequence , is the desired
run list of the compressors, with the left-
most compressor being the BASE load,
and the right-most compressor being the
TRIM.
This is where the operating parameters
are setup for the Networked modes of
operation.
The Load and Unload points are
confi gured from a base load machine and
are automatically assigned, based on the
STEP value based on the compressor’s
position in the desired sequence.
EXAMPLE: If the Base load compressor (‘A’)
has the pressures assigned as to the left,
then the ‘B’ compressor, would have
NET SETUP:
25