UNLOCKING SYSTEM WITH LEVER 1) Open
the protective plastic locker of the unlocking system.
During maintenance, always check the calibration of the anti-crushing clutch and the effectiveness of the safety devices.
If it is necessary to move the gate by hand - due to lack of electricity or automation
failure - use the unlocking device as described below.
6. RESUMPTION OF NORMAL OPERATION
3) Open or close the door manually.
Periodically check the amount of oil inside the engine.
2) Pull the lever in the unlocking system housing.
UNLOCKING SYSTEM WITH LEVER 1) Close
the unlocking lever in its seat.
4.3. AUTOMATION TEST
To refill, unscrew the filler cap and pour oil to the proper level
To prevent an involuntary impulse from activating the gate during the maneuver, before re-blocking the actuator, disconnect the
equipment's electrical supply.
months.
For medium-low frequencies of use, an annual check is sufficient. For more intense jobs, it is advisable to do it every six
3) Close the plastic protection box of the unlocking system.
For any repair, go to an authorized center.
Once the installation is complete, carefully check the operation of the automation and all the accessories connected to it. Give the
customer a copy of the "User Guide" and illustrate the correct operating conditions and use of the gearmotor, highlighting the
potential danger areas of the automation.
2) Open or close the door until the unlocking system engages.
7.1. OIL REFILL
5. MANUAL OPERATION
The descriptions and illustrations in this manual do not imply any obligation. The manufacturer reserves the right,
leaving the essential characteristics of the devices unchanged, to provide, at any time and without committing to
updating this publication, all the modifications it deems appropriate for technical improvement or for any other type of
requirement. constructive or commercial.
7. MAINTENANCE
8. REPAIRS
WARNING
Machine Translated by Google
