quiko MOOVY QK-M1200, Руководство по эксплуатации и обслуживанию

Страница: 8 / 22

8
GENERAL ADVICE
Install a gate’s safety system that complies with current regulations. Choose short routes for cables and keep
power cables separate from control ones. Install the control card in a waterproof box. Please refer to current
regulations when setting the gear motor’s maximum torque. We advice you to install an outdoor switch, in
compliance with European standards on the issue of safety, to turn the electricity off when servicing the gate.
Check that each single installed device is efficient and effective. Affix easily readable signs warning about
the presence of a motorised gate.
USE
It is absolutely forbidden to use the device for any other purposes. The installed electronic unit (which must
have built-in electric friction), allows to select the following functions:
automatic: one control impulse will open or close the gate;
semi-automatic: one control impulse will open or close the gate.
In case of a blackout, manual operation is possible by activating the unlocking device.
Having an automatic and electric power device requires special attention in a few situations:
- not to touch the device with wet hands and/or wet or bare feet;
- to turn off electricity before opening the control box and/or actuator;
- not to pull the lead to pull the plug out;
- to put the gate in movement only when it is completely visible;
- to keep out of the gate’s range of action if it is moving. Wait until it has stopped;
- not to let children or animals play near the gate;
- not to let children use the remote control or other operating devices;
- to carry out routine maintenance;
- in case of failure, to turn off electricity and operate the gate manually only if it is
possible and safe. Refrain from touching the gate and call an authorised technician.
MAINTENANCE
The MOOVY SERIES geared motors are manufactured for long-term use. Nonetheless, their normal
operation can be compromised by the conditions of the gate; therefore, we will list some operations to keep
the gate efficient.
Warning: Non-specialized staff cannot operate the gate during maintenance. You are advised to cut the
network power in order to avoid accidents or shocks. If the power must be on for various inspections, you
are advised to check and/or deactivate any possible control devices (remote controls, keyboards, etc…)
except for the devise used by the maintenance operator.
Routine maintenance
Each of the following operations must be done when needed and in all cases at least every 6 months:
Gate
! Lubricate the gate’s sliding wheels;
! Check the cleanliness and air-tightness of the rack.
Automation System
!
Check the operation of the safety devices (photo-cells, ribs, torque limiter) using the methods
described by the suppliers
Extraordinary Maintenance
If special maintenance is required for mechanical parts, you are advised to send the
gear motor out for repairs to be performed by the technicians at the manufacturer.