Avoid Back drafts
Care should be taken to avoid back drafting combustion appliances that are
installed in the conditioned space. It is strongly recommended that combustion
appliances NOT be installed in such a manner that they use room air for
combustion. Whole house fans are capable of pulling large quantities of air
from the home and particularly if not enough windows are open. This could
easily back draft gas appliances located inside your home.
Look through the hole and make sure there are no kinks or twists in the
ducting. Pull the ceiling box down through the hole in the ceiling. While
holding it in place, install a 1-3/8” drywall screw through the drywall into the
box on each side to temporarily hold the box in place.
Remove ceiling grill and screws from its packaging. Center the grill over the
ceiling box. Install the grill with the white screws provided by screwing
Some ceiling surfaces are uneven and
may cause a small gap to be present. This can easily be caulked later if
excessive.
Wiring Options
Return to the attic and go to each location. Using the nylon straps and the pan
head screws provided, support the duct to the framing. This will stabilize the
entir e assembly.
Replace any ins ulation that was removed. The installtion is now complete
except for the electrical wiring.
Once all of the QuietCool fans are hung, it’s time to go below and install the
ceiling box and ceiling grill at each intake location.
1
1
.
7.
8.
9.
1
0
.
VERY IMPORTANT! M
ake sure the fan blade spins freely. This is
very important to system operation.
!
I
8a
8b
9
10
11
!
ties of air
TThis could
!
Local building codes and standards must be adhered to in the installation
of this unit.
Visually
inspect
Repeat these steps at each location
A.) Using Remote Controls
-
When
using remote controls, the attached
power cord(high speed only) must be used and
a 120 v. three prong plug
outlet is required within six feet of the motor head in attic.
B.) Using attached power cord and hard wiring
to wall switches
-When
using the attached power cord(high speed only), a 120 v. three prong
plug outlet is required within six feet of the motor head in attic.
C.)
Using multi-speeds and hard wiring to wall switches
-
When Wiring
a
two
speed fan,
y
ou need to remove the 3 prong power cord and
direct
wire your fans to a 3 way switch.
Power must not be on both speeds at the same time
!
Install
Batteries &
Test Remote
Wiring Diagram with Optional Remote Control
Simple “plug and play”
Plug in Controller
Base
Plug fans into
module
Power
Source
Two wire
with
Romex
cable
ground
One QuietCool
Fan per outlet
Note: See Remote Instructions for Programing
Содержание QC-1500
Страница 1: ......
