1-888-QUIETCOOL
10
2.4 Pairing the Wall Switch
1.
Remove the mounting plate from the back of the switch and install the included AAA
batteries into the switch by removing the plastic covers. All the LED indicators will
light up indicating that the switch has power. Replace the plastic covers.
3.
Press and hold the Pair button on the Hub. The Pair LED indicator will be on for three
seconds then turn off. This clears all previous pairings out of the Hub,
4.
Press the Pair button on the Hub twice. The Pair LED indicator will blink once every
second indicating the Hub is in pairing mode.
5.
Press any of the buttons on the Wall Switch to wake it up. Now hold one of the
buttons on the switch. The Pair LED indicator on the Hub will go out and the Wall
Switch speed indicators will be blinking indicating successful pairing. Press one of
the Wall Switch buttons again, the speed indicators will go out, and it will display the
current fan status.
6.
Press the Timer button to test the Wall Switch to make sure it is communicating with
the Hub.
NOTE:
If a button on the Wall Switch is not pressed within three minutes of
pressing the Pair button on the Hub, the LED indicator on the Hub will go out,
indicating unsuccessful pairing. You will need to go back and repeat steps 4 and
5.
2.5 Finding a Location for the Wall Switch
1.
It is very important to find the correct location to install the Wall Switch that will allow
the Wall Switch to communicate with the Hub.
2.
Find the location you would like to install the Wall Switch and test that it properly
communicates with the fan to turn the fan on and off.
3.
If the fan comes on, this is a good location.
4.
If all the LED indicators turn on, the Wall Switch is not communicating with the Hub and you
will need to find a location closer to the fan.
!
!
