Operation Manual - Port
Quidway S5000 Series Ethernet Switches
Chapter 1 Ethernet Port Configuration
1-6
Operation
Command
Restore the default link type, that is, the access port.
undo port link-type
You can configure three types of ports concurrently on the same switch, but you cannot
switch between trunk port and hybrid port. You must turn it first into access port and
then set it as other type. For example, you cannot configure a trunk port directly as
hybrid port, but first set it as access port and then as hybrid port.
By default, the port is access port.
1.2.10 Add the Ethernet port to Specified VLANs
The following commands are used for adding an Ethernet port to a specified VLAN. The
access port can only be added to one VLAN, while the hybrid and trunk ports can be
added to multiple VLANs.
Perform the following configuration in Ethernet port view.
Table 1-10
Add the Ethernet port to specified VLANs
Operation
Command
Add the current access port to a specified VLAN
port access vlan
vlan_id
Add the current hybrid port to specified VLANs
port hybrid
vlan
vlan_id_list
{
tagged
|
untagged
}
Add the current trunk port to specified VLANs
port trunk permit vlan
{
vlan_id_list
|
all
}
Remove the current access port from to a specified VLAN.
undo
port
access vlan
Remove the current hybrid port from to specified VLANs.
undo port hybrid
vlan
vlan_id_list
Remove the current trunk port from specified VLANs.
undo port trunk permit vlan
{
vlan_id_list
|
all
}
Note that the access port shall be added to an existing VLAN other than VLAN 1. The
VLAN to which Hybrid port is added must have been existed. The one to which Trunk
port is added cannot be VLAN 1.
After adding the Ethernet port to specified VLANs, the local port can forward packets of
these VLANs. The hybrid and trunk ports can be added to multiple VLANs, thereby
implementing the VLAN intercommunication between peers. For the hybrid port, you
can configure to tag some VLAN packets, based on which the packets can be
processed differently.
1.2.11 Set the Default VLAN ID for the Ethernet Port
Since the access port can only be included in one VLAN only, its default VLAN is the
one to which it belongs. The hybrid port and the trunk port can be included in several
VLANs, it is necessary to configure the default VLAN ID. If the default VLAN ID has
been configured, the packets without VLAN Tag will be forwarded to the port that
belongs to the default VLAN. When sending the packets with VLAN Tag, if the VLAN ID
