Adjust the Gear mesh between the
Main gear and the Counter Gear on the
Front Tail Transmission using a double
thick piece of notebook paper in
between the 2 gears and adjust the Tail
Transmission by pushing tight against
the main gear. Remember the gear
mesh should be smooth readjust if
necessary.
Step 2 – Clutch Bell Installation
Install (1) Clutch Lining into (1) Clutch
Bell using JB Weld or 30 min epoxy.
Note: The clutch lining length prior to
installation should be 121.9mm cut if
necessary. Also note that we score the
inner portion of the clutch bell where
lining is glued with 80 Grit Sandpaper.
Replacement Part #:
Clutch Bell w/ Lining – QD350
Clutch Lining – QD351
