Quicksilver 675 Pilothouse, Руководство пользователя

Страница: 43 / 60

31
Quicksilver 675PH — System & Component Overview and Operation
To start the engine, the control unit must be in the NEUTRAL position. When in neutral, the engine is
running, but the propeller is not spinning. There is a throttle only button that when pressed, will
allow you to operate the throttle without the propeller spinning. On the mechanical shift controller,
the button is located at the center of the throttle control, and when moved back to the center
position, the button will automatically re-engage the shifting mechanism.
For the DTS control, the Throttle Only button is located on the lever below the handle grip. To
engage, press and hold the “Throttle-Only” button on the lever when the engine is in neutral. When
you place the ERC in gear, the warning horn will beep, however, the propeller is not turning. To
disengage “Throttle-Only” return the ERC lever back to neutral.
Moving the control lever forward from neutral engages the forward gear and throttle advance.
Moving the control lever backwards from neutral engages the reverse gear and thrust. The throttle
lever controls the RPM of the engine and the speed of the boat.
For the DTS control, there is a Stop/Start button. This button allows engine to be turned on and off
independent from the master key switch.
Power Trim & Tilt
The power trim, located on the side of the gear shift throttle handle, allows you to raise and lower
the engine for trailering and launching the boat. It also allows you to adjust the engine to create the
optimum run angle for the boat to achieve best all around performance (fuel consumption, speed).
REFER TO OWNER’S MANUAL PACKAGE FOR INSTRUCTIONS AND WARRANTY INFORMATION.
13. Emergency Engine Shutdown Switch
Your boat is equipped with an ignition shutdown safety switch built into the engine control. The
ignition shutdown switch incorporates a shut-off switch and a lanyard. Before operating the boat,
one end of the lanyard must be connected to the shut-off switch while the other end is connected to
the operator. If an emergency arises where the engine must be shut down, pull the lanyard cord to
release it from the shut-off switch, which in turn shuts down the engine. This switch is designed to
shut the engine off when the operator of the boat leaves the control station, either accidently by
falling into the boat, or by being ejected overboard.
The lanyard should be long enough to prevent inadvertent activation. Do not let the lanyard become
entangled.
Engine Controls
Engine trim
“Throttle Only” button
Engine stop / start
Ignition shutdown safety switch
Mechanical
DTS