Quickie Quickie Revolution, Руководство пользователя

Страница: 33 / 47

29 Revolution Issue 5
Chair adjustments
Rear axle camber
Wheel camber (Fig. 36) is
determined by your choice of
camber bar and axle clamps.The
tubes and clamps are available in
0°, 4°, 8° and 12° settings from
Sunrise Medical dealers. To change
the camber setting the camber bar
and clamps must be removed by
removing the two retaining screws
and nuts per clamp following the
procedure for seat height, and
fitting the desired camber bar and
axle clamp. The screws must be
tightened to 7-12Nm.
Warning
Always ensure the camber tube
and clamps angle match.
Top view of chair
Fig. 36
0 O Clamp Tube
4 O
8 O
12 O
Fig. 37a 3 2 1
Toe out Straight Toe
in
Fig. 37b Front of wheelchair
Rear axle toe in or toe out
The correct wheel position is set at
the factory. Should you change the
seat angle, you must always check
the toe in/toe out. (Fig. 37b).This
can be adjusted (Fig. 37a) by
removing the side plate (1), and
loosening the eccentric washer
retaining screw (2). Note, it must
clear the housing (3), and turning
the washer through the desired
amount. Once the desired setting is
reached tighten the screw (2) to
7-12Nm and replace the side plate,
tightening all screws to7-12Nm
Allen key size 4mm.
Warning
both wheels must have equal
amounts of toe in or toe out. The
maximum is 15mm.