932110 Rev. C
22
E n g l i s h
V I I I . S e t - u p , A d j u s t m e n t & U s e
H. SHROUD AND COVER REMOVAL
1. Shroud Removal (Figure 11)
The color shrouds are attached to the black plastic cover by Velcro and can be removed by
gently pulling them off.
2. Cover Removal (Figure 12)
a. Unscrew the set screw (L) beneath the chair.
b. Remove cover by pulling it out towards the end of the footplate.
c. Reverse this procedure to reinstall the cover.
I. CHECK-OUT
Once the wheelchair is assembled and adjusted, it should roll smoothly and easily.
All accessories should also perform smoothly.
After the wheelchair has been set up be sure the chair performs to your specified opera-
tional settings (see Operating Guide). If the chair does not perform to specifications, turn
the wheelchair OFF immediately and reprogram operational specifications using the QTRONIX
Programming Pad.
Repeat this procedure until the wheelchair performs to specifications before attempt-
ing active use of the wheelchair.
If you have any problems, follow these procedures:
1. Review the Set-up, Adjustment & Use section and Operating Guide to make sure chair
was properly prepared.
2. If your problem persists, contact your authorized supplier. If you still have a problem
after contacting your authorized supplier, contact Sunrise customer service. See the
introduction page for details on how to contact your authorized supplier or Sunrise
customer service.
11
12
L
