Quicke Q20, Техническое руководство

Страница: 22 / 47

4:4 2005-09
Installation
9
0
4
0
0
1
2
1
0
7
a
_
mo
n
t
a
v
la
st
a
re
_
tm.
in
d
d
Install the level indicator
Install the level indicator on the tilt cylinder. Adjusting is
done with each tool installed. The indicator can be installed
on the right or left sides. Indicator (B) is installed for left
installation and must be moved for right installation.
Set the tool in level position, adjust the reference indicator
(A) directly opposite the indicator (B). Check that the
indicator runs freely, adjust if needed. The indicator hose
(C) should be parallel to the tilt cylinder. Incorrect adjust-
ment can cause the device to self-destruct. When adjusting
after a tool change, set the tool level, move the reference
indicator (A) centrally against the indicator (B).
Install the position indicator on the tilt cylinder.
Check list
When the loader has been installed - check carefully that
everything works before it is taken into service. The
following points must always be checked. Mark them off
and do the necessary adjustments if necessary.
Check that everything has been installed in accordance
with the installation instructions.
Check that a counterweight is fitted, which is required
for the tool and application.
Check that all screws are tightened.
Check that the front wheels clear the loader and base
during full wheel lock and oscillation of the front axle
- if this is not the case, oscillation stops or limitation of
steering lock must be installed.
Check that the green end of the Lock & Go lock pin is
visible on the inside of both the left and right bearing
housings.
Check that no oil leakage occurs.
Operate all loader functions several times to remove air
from the system.
Check the tractor oil level - top it as necessary.
Check that the lock pins engage when a tool is
connected.
Check that the loader does not have any visible defects.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.