Quick RDS 1562, Руководство по использованию и установке, Страница: 26 / 36

26
EN
RDS 1562 - IT EN - REV001A
PROGRAMMING
RDS 1562 INSTRUMENT’S CONFIGURATION MENU
The parameters which can be selected and changed in this menu only concern the remote panel RDS 1562. All applied
changes won’t be transferred to the battery charger the instrument refers to.
MENÙ RESET
RESET
This function resets the battery charger even if there are errors with manual reset.
It should be noted that if the cause of the problem is not removed, the problem
will occur again.
NO
YES
LANGUAGE MODE
RDS GROUP MODE
RDS PRIORITY MODE
NETWORK SCANNING MODE
LANGUAGE
This function allows to choose the language of the main and secondary menu.
English * * Factory setting
Italiano
Francais
Espanol
Deutsch
Exit
RDS GROUP
This function allows to attribute to the instrument the same network group of the
NRG+ battery charger connected to it.
Ensure that you assign to the instrument the same group of the battery charger
of which you want to display the data.
A GROUP* * Factory setting
B GROUP
C GROUP
RDS PRIORITY
This function allows to attribute to the instrument the same priority of the NRG+
battery charger connected to it.
Ensure that you assign to the instrument the same priority of the battery charger
of which you want to display the data.
1 PRIORITY* * Factory setting
2 PRIORITY
3 PRIORITY
NET SCANNING
This function scans the network and checks the group and the priority of the
battery chargers connected to the CAN bus network. If there are several battery
chargers in the network, use the
p
and
q
(UP and DOWN) buttons to display the
group and priority of all the battery chargers connected to the network.
p
N E T S C A N N I N G
S E A R C H I N G . . .
g
N E T S C A N N I N G
B A T T E R Y C . A 1
q
SILENT MODE
SILENT MODE
This function allows to reduce the acoustic noise generated by the battery
charger.
When the “Silent mode” is enabled, the maximum speed of fans is limited to a
value lower than the nominal one.
The battery charger in this mode, if needed, carries out a reduction of the
maximum output current according to the temperatures measured by the two
sensors inside the battery charger.
In case of battery chargers connected in parallel (current sharing mode), the
selected option must be the same in all battery chargers.
Disable *
* Factory setting
Enable
Exit