Quick P902, Руководство по установке и использованию

Страница: 5 / 12

5
MAINTENANCE - TECHNICAL DATA
GB
RRC P902/904 - REV000A
MODELS P902 P904
INPUT CHARACTERISTICS
Power supply CR2450 3V lithium battery
Absorption during transmission 13 mA
CHARACTERISTICS OF THE TRANSMITTER
Number of keys 2 4
Carrier frequency 913.7 Mhz
Modulation FSK
FCC ID O2W-TXP
GENERAL
Operating temperature from -15°C to +70°C
Dimensions (W x H x D) 60 x 47 x 23 mm
Weight (including the battery) 34 g
TECHNICAL DATA
QUICK ® RESERVES THE RIGHT TO MODIFY THE TECHNICAL CHARACTERISTICS OF THE EQUIPMENT AND THE CONTENTS OF THIS MANUAL WITHOUT PRIOR NOTICE.
TRANSMITTER
BASE
CR2450 3V LITHIUM
BATTERY
SCREWS
TRANSMITTER
FRONT
BATTERY
HOLDER
MAINTENANCE
The RRC pocket radio transmitter does not require particular maintenance. Use a soft cloth moistened with water when
cleaning it. Do not use chemical or abrasive products.
BATTERY REPLACEMENT
P902-P904 MODELS
WARNING: before operating on the transmitter, make sure that the RRC radio receiver is not powered. Acciden-
tally pressing a key may activate the corresponding device and create a dangerous situation.
WARNING: danger of explosion if battery is replaced with an other of incorrect type.
• Remove the transmitter base by unscrewing the four screws using a
Phillips screwdriver.
• Remove the battery from the battery holder sliding it outwards with-
out using metal tools.
• Insert the new battery (of the type indicate in the technical character-
istics) paying attention to polarity of the positive pole (+) as shown on
the metal battery holder.
• Close the transmitter base, checking that it sits correctly in the gasket
groove, located on the front of the transmitter, in order to restore the
seal.
• Tighten the four screws.
WARNING: once the transmitter is assembled, verify that the
LED does not remain on constantly. If the LED is on, reopen the
transmitter and verify that it was assembled correctly.
At the end of its useful life, the battery contained in the product must
be disposed of separately from other separated urban waste. Dispose
of the battery in accordance with the provisions of local law.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) this device must accept any interference received including interference that may cause undesired operation.
F