41
4.
Avoid sliding block into foreign body to affect life.
How to inject the grease:
1.
Stop the unit. Inject into the nozzle 0.7cc grease.
2.
Allow the slider to move back and forth, allowing the inner steel to roll completely.
Repeat
①
&
②
, inspect whether grease adhere to the end of track.
6.2.6 Maintenance of ball screw
1.
Inject grease with grease gun by many times. Roll the screw spindle half-turn after injecting
one time (Inject 0.7cc each time). Notice: Do not inject rated grease, otherwise it will not be
lubricated completely.
2.
Finished lubricating rated grease, Push the block for a round trip to spread grease.
3.
Daily maintenance of the wire feeder unit
4.
The tube of solder wire feeder would be blocked by the rosin after a long period of using.
Check and clean it (with alcohol) regularly.
5.
Do not over bend or rotate the tube in case of wire jam.
6.
Check if the diameter of the tube assembly is same as which of the wire feeder.
7.
Turn the pressure adjustment screw clockwise if the wire cannot be fed smoothly. Turn it
anti-clockwise if the wire was pressed too much.
8.
Do not tighten the press adjustment screw too much to protect the press spring.
6.2.7 Daily maintenance of heating controller
1.
Turn off the heating controller when not in use. Pull out the power cable if not use it for a
long time.
2.
Reliable grounding is essential for the soldering robot. Do not use the power cable without
ground.
3.
Replace the fuse of the heating controller if it is broken: Turn off the heating controller, pull
out the power cable, remove the fuse cover, take out the defective fuse and put a new one.
