29
INSTALLATION
EN
RETRACTABLE THRUSTER BTR185 - IT EN - REV008B
Fig. 20
CAM 1
CAM 2
PLASTIC SUPPORT
PLASTIC SUPPORT
FIXING SCREW
Actuator’s interior
SWITCH FC1
SWITCH FC2
ADJUSTMENT OF THE THRUSTER’S
MAXIMUM CLOSING
ADJUSTMENT OF THE THRUSTER’S
MAXIMUM OPENING
CAM
0FF
ON
Fig. 21
•
To adjust the FC1 and FC2 limit switches, partially unscrew the fixing screw and move them on the
right or on the left according to the need, then screw the fixing screw back on (fig.
20
).
WARNING:
while adjusting the limit switch FC1 and FC2, verify that the cam which operates
them is always positioned between them and never in overstroke.
•
Disconnect the BTR propeller from power for at least five seconds (fig.
21
).
•
Connect power to the BTR propeller (Fig.
21
).
•
Enable a TCD control connected to the BTR propeller to open the propeller and activate it (fig.
22
).
•
Disable the TCD control before hand enabled in order to close the propeller (fig.
19
).
•
Ensure that the high-absorption protection did not intervene (the “ERROR” LED must be switched
off - fig.
18
/ Part.
D
).
• Open the thruster completely by switching it on by the remote
(fig.
22
).
WARNING:
once the thruster is open,
disconnect power
supply
(fig.
21
) in order to lock it into this position.
• Insert the two limit switch wires in the proper slots.
• Position the two cable-stoppers, apply tension to the two wires,
checking that both springs are equally pulled, tighten the ca-
ble-stoppers by means of a 2,5 mm hexagon wrench key.
• Lock the cable-stopper by tightening the counter nut by means
of a 8 mm open end wrench, cut with a cutting nipper the excess
cable leaving about 20 mm besides the cable-stopper.
• Power up the thruster (fig.
21
) which will automatically close.
• In order to ensure that the thruster is properly working, open the
thruster several times using the control (fig.
22
).
Opening of the actuator’s side lid
Actuator’s adjustment
Installation of the springs’ limit switch wires
Fig. 22
Fig. 23
Fig. 23
LIMIT SWITCH
WIRE
CABLE-STOPPER
COUNTER NUT
SPRING
20 mm Max
Содержание BTR185
