Quick BTQ 110, Инструкция по установке и эксплуатации

Страница: 16 / 24

BTQ Series
EN
QUICK BTQSeries INSTALLATION AND USER’S MANUAL - REV003A
16
6.1 - Thruster use
Start-up
Start-up happens following activation of a TCD panel.
To use the propeller, refer to the TCD control manual.
6 - Cautions & Use
6.0 - Important cautions
• This thruster is not designed for continuous use. It is equipped with protections which limit its operation at
a maximum time span, as reported on the controls’ manual. It is strongly forbidden to bypass or modify such
protections in order to increase the operating time span, lest voiding the warranty and thus lifting any responsibility
from Quick
®
SPA.
• Make sure no swimmers or floating objects are in the vicinity before switching on the thruster.
• There must not be flammable materials in the peak or in the area where the Thruster motor is.
• Do not operate the bow thruster out of the water for more than 10 seconds.
• During mooring, it is recommended not to leave in the water any free line, which may be sucked in by the
propellers, thus leading them to break.
SINGLE PROPELLER DOUBLE PROPELLER
NOTE:
the bow thruster must be installed with the propeller
to the right of the gearleg (see figure).
NOTE:
the bow thruster must be installed with the RH
propeller to the right of the gearleg (see figure).
RH RH
If it is necessary to install the bow thruster in the opposite
position, the connection of the two cables (blue and grey)
of the control cable on the reversing contactor must be
reversed.