Quantum StorNext QD7000, Руководство по оборудованию

Страница: 130 / 141

Note: Complete all connections by using Fibre Channel cables of the correct length.
Steps
1. Determine whether you adding equipment for mirroring to an existing storage array environment.
• If so, stop I/O activity from all hosts before proceeding. Go to Step 2 on page 121.
• If not, this is a new storage array installation. Go to Step 3 on page 121.
Attention: Possible hardware damage – DC-powered controller-drive trays have special
power procedures that you
must follow beyond the procedures for AC-powered trays. To get
specific power-off and power-on procedures, see the installation instructions for your storage
array.
2. Turn off the power to all storage arrays, hosts, Fibre Channel switches, and any other equipment
in the storage array environment.
3. Make sure that basic cabling between all of the controller-drive trays and the drive trays on both
storage arrays is complete.
Note: Depending on which site is being configured, switch 1 represents switch 1A for the
primary site and switch 1B for the secondary site.
Note:
You can connect the cables to any port in the correct zone of the switch.
4. Connect the primary host bus adapter for each host at this site to an available port in zone 1 of
switch 1A.
The following figure shows the cabling that is described in Step
4
on page 121 and Step
5
on page
121.
5. Connect the secondary host bus adapter for each host at this site to an available port in zone 2 of
switch 1A.
The following figure shows connections between a host bus adapter and a Fibre Channel switch.
3
2
5
4
7
6
9
8
11
10 12
13 15
14
1
0
Zo ne 2
Zo ne 1
S witc h 1A
75088
Zo ne 3
Zo ne 4
Ho s t 1
HBA1a HBA1b HBA2a HBA2b
Ho s t 2
Ho s t Gro u p
6. Connect controller port A1 of the storage array to an available port in zone 1 of switch 1A.
The first figure following Step
9
on page 122 shows the storage array connected to Fibre Channel
switches that is described in Step
6
on page 121 through Step
9
on page 122. The second figure
Hardware installation for Synchronous Mirroring and Asynchronous Mirroring | 121