Procedure
Quantum Smart-1 6000-L/6000-XL Appliances Replacing SAN Cards | 14
5. If DC PSUs are installed in the appliance:
Connect the safety ground wires from the DC PSUs.
Connect the DC power connectors from the DC PSUs.
6. If you opened the hook-and-loop straps, close them to secure the system cables.
7. Make a loop and secure the power cables to the PSUs using the retention strap.
8. Press the Power button on the front panel to turn on the Security Appliance.
Replacing a Transceiver
If your expansion SAN card contains removable transceivers, you can install and replace these
transceivers.
Note - The optical transceivers on the SAN card are delicate.
n
Remove and install the transceivers carefully.
n
Use ESD (Electrostatic Discharge) precautions such as an antistatic floor mat and an antistatic wrist
strap.
n
Store transceivers in a safe place using ESD (Electrostatic Discharge) precautions such as antistatic
bags.
To install a transceiver:
1. Push the transceiver into an expansion SAN card port gently until it snaps into position.
2. Turn the transceiver latch lever up to lock into the expansion SAN card.
3. Connect the fiber optic cable to the transceiver.
To remove a transceiver:
1. Disconnect the fiber optic cables from the transceiver.
2. Pull the latch lever down to release the transceiver.
3. Gently, pull the transceiver out of the expansion SAN card.
