Install Rails (Square, Round, Pre-tapped Hole-Racks)
QXS 48-Drive Rackmount Install Guide
17
c. Before rail installation, refer to
Figure 18 below
for screw location and placement of the rail for
mounting to the rear of the rack.
d. The rails go over the outside of the rack.
Figure 18:
Screw Locations for Mounting Rails (rear)
3
2
3
4
4
1
1.
Left Rail
2.
Right Rail
3.
Pre-tapped Hole-Rack
4.
Screw Locations to Install Rail
Position the rail's front and back mounting flanges so that through holes align with corresponding rack
holes, and note the locations.
Note:
Align the bottom of the rail with the bottom of the rack unit where you would like to install the
rails. Rails should not be installed where the rail will straddle rack units (U). Most racks provide
alignment markers indicating the rack units used for rail installation.
Refer to
Figure 19 on the next page
for placement of the rails within the rack. The red "
X
" identifies the
height of the chassis (2U) to be installed.
Note:
The rail kit supports either the RAID (controller) or expansion chassis.
On the following diagram (representative rack only used for chassis placement), elevation numbers are
arbitrary and represent vertical location within the rack.