ATL P1000 Series Library Unpacking Instructions
Document 6221100-02, Ver. 2, Rel. 0
March 1999
16
Installing the Slide Assembly in the Rack
Procedure (continued)
7
Remove the two 10-32 x 3/4 in. temporary support screws from the
front retma rails and install them in the left and right rear
mounting brackets to secure the rear mounting brackets to the rack
retma rails.
8
Remove the two 10-32 x 3/4 in. temporary support screws from the
rear retma rails and use them to finish securing the rear mounting
brackets to the rack retma rails.
Note:
Do not tighten the nuts securing the rear mounting brackets to
the slide assembly. You will tighten these during the following
procedure, “Adjusting the Slide Assembly.”
9
Remove the four temporary support screws.
Figure 10 Installing the
Slide Assembly in the Rack
Slide assembly
Support screw
Mounting screws
Mounting screws
Support screw
Front mounting bracket
Rear mounting
bracket
Retma rails