ATL P1000 Series Library Unpacking Instructions
Document 6221100-02, Ver. 2, Rel. 0
March 1999
Packaging the Library for Reshipment
31
Packaging the Library for Reshipment
20
If it becomes necessary to reship the library, repackage the library in its
original shipping materials as follows:
Procedure
1
Unload and eject all tape cartridges from the tape drives.
2
Turn off the library and disconnect all cables.
3
Open the library doors:
a
Using the key in the accessories kit, unlock the front door of the
library.
b
Open the left door first, then open the right door.
4
Remove the load and bulk packs (see figure 19 on page 29):
a
Grip the load pack handles and squeeze them together.
This releases the latches securing the load pack.
b
Still holding the load pack handles, pull the load pack forward
and out of the library.
c
Repeat steps 4a and 4b to remove the bulk pack.
Note:
In order to install the shipping restraint, the gripper must face
the front of the library.
5
If the gripper is facing the tape drives, rotate the extension axis so
that the gripper faces the front of the library:
a
Reaching through the library doors, move the gripper
backwards (away from the tape drives) and compress it against
its rear limit.
This unlocks the rotary assembly and permits the extension
axis to rotate.
b
Rotate the extension axis assembly 180° so that the gripper
faces the front of the library.
c
Jiggle the extension assembly slightly to relatch the rotary
assembly.
6
Secure the extension axis assembly:
a
Center the extension axis assembly between the mounting
blocks for the load and bulk packs.
b
Raise the extension axis assembly and place the foam block
beneath it.
