4
Installing the Internal LTO-3 Half-Height Tape Drive
LTO-3 Half-Height Tape Drive Quick Start Guide
2
Connecting the Internal Drive Interface and DC Power Cables
on page 8
3
Restarting the Internal Tape Drive System
on page 9
4
Installing the LTO Driver Software
on page 13, if required
5
Registering the LTO-3 Half-Height Tape Drive
on page 13
Configuring the Internal
Parallel SCSI Tape Drive
0
The factory-set default configuration of the internal parallel SCSI LTO-3 Half-Height Tape
Drive is:
• SCSI ID: 6
• Terminator power: enabled
Configuring the Internal Drive Parallel SCSI ID
0
Each device on the parallel SCSI bus must have its own unique SCSI ID. Use SCSI
configuration jumper pins 1–2, 3–4, 5–6, and 7–8 on the drive back panel to change the
SCSI ID of the LTO-3 Half-Height Tape Drive (see
figure 2
).
serial-attached SCSI (SAS),
there is no need to configure the SCSI ID or bus
termination, as SAS is a point-to-point architecture.
Skip to
Mounting the Internal Tape Drive
on page 6
IF the default parallel SCSI ID
configuration is . . .
THEN you can . . .
compatible with your system
SCSI bus,
skip the following subsection and proceed to
Configuring the Internal Parallel SCSI Terminator
Power
on page 5.
already assigned to another
device,
change the configuration of either the other
device, or the LTO-3 Half-Height Tape Drive, as
described in the following subsection.
IF the drive interface is . . .
THEN . . .
