Quantum DXi-Series Command Line Interface (CLI) Guide
6-67081-05 Rev B
April 2012
82
Network CLI Commands
Disabling Jumbo Frames
syscli --disable jumbo
DEPRECATED. Use the syscli
--add netcfg
command to set jumbo frames
instead.
Getting Jumbo Frame Status
syscli --getstatus jumbo
DEPRECATED. Use the syscli
--list interface
command to get jumbo frames
instead.
Setting Up a Segmented Network
syscli --setnetwork segmented
DEPRECATED. Use the syscli
--add netcfg
command with the -
-segments
option
instead.
Setting Up an Unsegmented Network
syscli --setnetwork unsegmented
DEPRECATED. Use the syscli
--add netcfg
command with the
--segments
option
instead.
Querying the Network
syscli --query network
DEPRECATED. Use the syscli
--get network
command instead.
Undoing a Network Configuration
syscli --undo netcfg [--sure]
DEPRECATED. No longer applicable in versions 2.1 or greater.
Netcfg Configuration
Examples
This section provides examples of advanced netcfg configurations and a brief
explanation of the syscli sequences that were used for each of the
configurations. These examples, which are intended for customer network
administrators, can vary depending on the customer network environment.
The following are some key points to remember:
• Use of the CLI commands require some understanding of network
configurations, and they must be used with caution.
• Bonded Ethernet ports must be connected to a switch, with the same link
aggregation setup (Round Robin or Link Aggregation Control Protocol).
The following netcfg configuration examples are not possible with the CLI GUI:
•
DXi 6540 Connected to Two Different Networks Through Two Bonds
