Quantum Rehab Vibe, Руководство пользователя

Страница: 38 / 47

38 www.quantumrehab.com Quantum Vibe
V I . O P E R A T I O N
Power Accessories
If your power chair is equipped with power accessories such as a power seat or power elevating leg rests, you can operate
them through the remote keypad. Contact your Quantum Rehab Specialist for information on how to operate these
accessories.
Off-board Charger/Programming Socket
The off-board charger connects to the Remote Plus through the 3-pin socket located on the front of the controller. See
figure 24. The off-board charger current should not exceed 12 amps. Contact your Quantum Rehab Specialist for more
information.
WARNING! Only chargers with Neutrik NC3MX plugs should be connected to the off-board charger/
programming socket. See your Quantum Rehab Specialist for more information.
Controller Communications Cable
The controller communications cable provides the joystick module with a connection to the power module. See figure 24.
Power Module (Not Shown)
Typically, the power module is mounted to the power base. The power module provides a power interface for the joystick
module. It routes the battery power to the motors and other powered accessories such as lights and power seats.
Actuator Lighting Module (Not Shown)
The actuator lighting module is also located on the power base. The actuator lighting module provides a control and power
interface between the power module, the lights and/or the power seat actuator.
Sleep Mode
Sleep mode is a built-in circuit that automatically shuts off the main power if the joystick is not moved in any direction for
approximately five minutes. The battery condition meter lights on the keypad indicate sleep mode by blinking once every
five seconds. To restore power and continue, push the on/off key twice.
Thermal Rollback
The thermal rollback circuit monitors the temperature of the motors, power module and remote. In the event that any of
them become excessively hot (above 50° C/122° F), motor voltage is reduced. For every degree above 50° C/122° F, the
voltage is reduced by 5 volts. This reduces your power chair’s speed and allows the electrical components to cool down.
When the temperature returns to a safe level, your power chair resumes its normal speed.