Quantum Rehab Vibe, Руководство пользователя

Страница: 33 / 47

Quantum Vibe www.quantumrehab.com 33
V I . O P E R A T I O N
On/Off Key
The on/off key turns the VSI on and off. See figure 23.
W A R N I N G ! U n l e s s f a c e d w i t h a n
emergency situation, do not use the on/
off key to stop the chair. This will cause
the power chair to stop abruptly.
WARNING! Always turn the power off
when you are stationary to prevent
unexpected movement.
Battery Condition Meter
The battery condition meter is located in front of the joystick.
See figure 23. This is a 10-segment illuminated display that
indicates that the VSI is powered on and also gives the battery
status, the VSI status and the electrical system status.
!
Red, yellow and green lights lit: Batteries charged; VSI
and electrical system OK.
!
Red and yellow lights lit: Charge batteries if possible;
VSI and electrical system OK.
!
Red lights only lit or slow flash: Charge batteries as
soon as possible; VSI and electrical system OK.
!
Rapid flash of lights: Indicates a fault in the VSI or the
electrical system.
Figure 23. VSI Controller Keypad
BATTERY CONDITION METER
MAXIMUM
SPEED/PROFILE
INDICATOR
*ACTUATOR
KEY
SPEED/PROFILE
DECREASE KEY
ON/OFF KEY
*ACTUATOR
LIGHT
*ACTUATOR
KEY
SPEED/PROFILE
INCREASE KEY
HORN
KEY
*For optional equipment on some models
*ACTUATOR
LIGHT
!
Ripple side to side of lights: The joystick was not in the neutral position when the controller was turned on. If you
get “ripple side to side of lights,” turn off the controller, allow the joystick to return to the neutral position, then turn on
the controller.
NOTE: If you still get “ripple side to side of lights,” contact your Quantum Rehab Specialist.
NOTE: When the batteries approach a discharged state, the first red light will begin to slowly flash, remind-
ing you the batteries need to be charged immediately!
Speed/Profile Keys
There are two keys that control either the speed or the profile. See figure 23. This depends on how your VSI was
programmed. Press the speed/profile increase key to increase the speed or change the profile. Press the speed/profile
decrease key to decrease the speed or change the profile. The speed/profile setting is displayed on the maximum speed/
profile indicator. If your power chair was programmed with a drive profile, contact your Quantum Rehab Specialist for
more information.
NOTE: We recommend that the first few times you operate your power chair, you set the speed to the slowest
setting until you become familiar with your new power chair.