INSTALLATION INSTRUCTIONS
ALL ELECTRICAL WORK SHOULD BE CARRIED OUT BY A COMP
1 Decide on a suitable location.
2 Mark the position for the 2 No.8 Woodscrews
3 Fit the screws leaving the screws protruding 15mm from the wall.
4 Mark the position on the wall for the 13A Fused Spur connection
5 Install the fused spur back box and supply cable
6 Mount the heater on to the 2 off No.8 Woodscrews
7 Ensure that the mains supply is turned
8 Connect the supply to the fused spur front plate.
9 Connect the unit to the front plate as described below
10 Replace the front plate.
11 Installation is now complete.
CONNECTION DETAILS
THIS UNIT MUST BE CONNECTED TO THE MAINS SUPPLY BY A SWITCHED SPUR
The wires in the cable attached to this unit are coloured in accordance with the following code:
BROWN
GREEN/YELLOW
BLUE
THIS APPLIANCE MUST BE EARTHED
As the colours may not correspond with the markings indentifying the terminals in the fused spur proceed as follows.
•
Blue wire must be connected to the terminal marked ‘N LOAD’
•
Brown wire must be connected to the terminal marked ‘L LOAD’
•
Green/Yellow wire must be connected to the terminal ‘E’ or marked
ALL ELECTRICAL WORK SHOULD BE CARRIED OUT BY A COMPETENT ELECTRICIAN
No.8 Woodscrews. (supplied)
Fit the screws leaving the screws protruding 15mm from the wall.
Mark the position on the wall for the 13A Fused Spur connection.
and supply cable. (Surface mount or sunken)
Mount the heater on to the 2 off No.8 Woodscrews.
turned off.
to the fused spur front plate.
front plate as described below.
THIS UNIT MUST BE CONNECTED TO THE MAINS SUPPLY BY A SWITCHED SPUR
The wires in the cable attached to this unit are coloured in accordance with the following code:
======================
LIVE
===
=
===
=
===
=
===
=
===
=
==
EARTH
====================
NEUTRAL
THIS APPLIANCE MUST BE EARTHED
As the colours may not correspond with the markings indentifying the terminals in the fused spur proceed as follows.
minal marked ‘N LOAD’
Brown wire must be connected to the terminal marked ‘L LOAD’
Green/Yellow wire must be connected to the terminal ‘E’ or marked
TENT ELECTRICIAN
THIS UNIT MUST BE CONNECTED TO THE MAINS SUPPLY BY A SWITCHED SPUR
The wires in the cable attached to this unit are coloured in accordance with the following code:-
As the colours may not correspond with the markings indentifying the terminals in the fused spur proceed as follows.
