QE7018
OPERATION
There may be a trace of smoke or odour during the first few minutes of initial use or when the unit has not been
used for a period of time. This is quite normal and will quickly disappear.
FROM THE FRONT PANEL
The unit is in standby mode (POWER light will be ON) while the FUSED SPUR is switched on.
To switch on the appliance press the LEFT HAND button on the front panels. The heater
will select FAN mode.
By pressing this button again will select 1000W low heat setting.
Pressing it again selects the 2000W high heat setting.
Pressing it again will turn the unit back to STANDBY MODE.
The timer can be set from ½ hour to 7 ½ hours by pressing the TIMER (RIGHT HAND) button.
This steps the time up by ½ hour with each press.
To turn off the unit switch off the FUSED SPUR.
FROM THE REMOTE CONTROL
The remote control requires two AAA batteries. (not supplied)
To switch the appliance on from the STANDBY mode press the RED button on the
remote control. The unit will switch on in the FAN only mode.
Pressing the 1000W button will select the low heat setting.
Pressing the 2000W button will select the high heat setting.
The timer can be set from ½ hour to 7 ½ hours by pressing the TIMER button which steps up ½ hour with
each press.
To turn off the unit press the RED button.
ATTENTION.
When the unit is switched off the unit will continue to blow cool air for 60
seconds before shutting down.
A thermal overload protector is built into the unit to prevent overheating
If the unit overheats it will shut down automatically.
