980 HDMI Protocol Analyzer Application Guide
– Source Compliance Test Automation
Rev. A1
Page 8
Feb 14, 2013
Ethernet connections for 980B using corporate LAN or hub
1. Connect an Ethernet cable from the 980/980B Ethernet jack on the back panel of the 980/980B to your
corporate LAN or local Ethernet hub. The IP address on this 980B Ethernet port is configurable using the
procedures that following. Refer to the diagrams above.
2. Connect an Ethernet cable from your Automated Test System to your corporate LAN or local Ethernet hub.
To make the physical connections using Ethernet Point-to-Point connection with the Automated Test
System:
This procedure is used when you are connecting your Automated Test System to the 980/980B directly with an
Ethernet cable. If you are connecting through your corporate LAN or local hub, use the previous procedure. This
procedure assumes that you have assembled the 980/980B, host PC for the Automated Test System and source
device under test and applied power to all these devices. Refer to the diagrams and procedure below. The first
illustration shows a direct Ethernet connection with the 980. The second illustration shows a direct Ethernet
connection with the 980B.
