Quantronix CUBISCAN 325, Руководство по обслуживанию

Страница: 43 / 98

PART REPLACEMENT Replacing the encoder
Cubiscan 325 Service Manual 3 3
–Zip ties
–Replacement encoder cable
Complete the following steps to replace the encoder
and attached cable.
1. Power off the Cubiscan 325.
2. Remove the two center cover thumb screws that are
located on the right side of the system. See
Figure 29 .
3. Slide the center cover to the left so that you can
access the controller.
4. Move the gate into the home position (the right side
if facing the front of the Cubiscan 325).
5. We recommend trying to work around the glass
platform without removing it. If it becomes a
nuisance, carefully lift the platform using two people
and set it aside.
6. Using the 3/32'' Allen wrench, remove the two
screws shown in Figure 30 that hold the encoder in
place.
7. Cut the two zip ties holding the encoder cable in
place.
8. Using the Phillips screwdriver, remove the two screws
holding the cable carrier bracket in place. Refer to
Figure 31 . The cable carrier bracket is located on the
underside of the gate, where the cable carrier meets
the gate.
9. Using the small Phillips screwdriver, remove the four
screws holding the other end of the cable carrier in
place. See
Figure 32 .
10. Unplug the power, encoder, and ribbon cables
indicated in Figure 33 .
11. Lay the cable carrier out flat.
12. Pop off the plastic cable carrier latches located on
top of the cable carrier. Refer to Figure 34 .
13. Remove the damaged encoder and cable and
discard it. Remove the end of the cable carrier if
Figure 30
Encoder screws
Figure 31
Cable carrier bracket screws
Figure 32
Cable carrier screws