Quant 3D Q150, Руководство пользователя

Страница: 33 / 58

3. Operation
33
Part Options
Surface: This parameter determines how many layers are needed to form the
bottom of a part. For example, if value is set to 3, the machine will print 3
complete layers before going into non-solid mode. This does not, however,
affect the side wall thickness on non-solid parts, which are all the same
thickness (approximately 1.5mm) regardless of the infill mode.
Angle: The part angle determines at what point solid (dense) support material
gets used. If the part angle is smaller than this parameter, the printer will add
solid infill layers under the part surface. The thickness of this solid (dense)
support is determined by the “
Dense” parameter under the Support options as
described below.
Figure 3-27 Support structure on different portion of parts
Fill Options
There are four modes for infill structures, as described below.
The part is made by dense infill, very close to solid
plastic, which makes the strongest part. This setting is
recommended for functional engineering parts. In
previous version, this option was referred as “Solid”
The part has an outer wall thickness of solid plastic
(about 1.5mm), but its interior is filled with a less dense
support structure. In previous version, this option was
referred to as “Loose”
The part has an outer wall thickness of solid plastic
(about 1.5mm), but its interior is filled with loosely
spaced structure. In previous version, this option was
referred as “Hollow”