Quanmax TOUCH TOY, Сетевое руководство

Страница: 4 / 14

Be careful which type of ADSL-access is available. Currently PPTP and PPPoE are the most widely used
ADSL-transmission protocols. You can get further information about the existing ADSL connection and the
required ADSL network addresses from the network administrator or your ADSL-provider.
The following ADSL-network addresses are required:
• Terminal IP address - only necessary with PPTP! (standard IP 10.0.0.140)
•
Router IP address
- only necessary with PPTP! (standard IP 10.0.0.138)
• User name
• Password
• DNS 1 (primary)
• DNS 2 (secondary)
For entering the configuration data press the Edit button, type in the configuration data, after all
required data are entered press Store-Button
Example of a single-location system via ADSL-modem without router:
The cable from the telephone socket is connected either directly or with a splitter to the ADSL-modem.
The Touch Toy terminals network card is connected to the ADSL-modem via an Ethernet network cable.
2.2.4 Internet connection with LAN
If the LAN type of connection was selected, there is a choice between two possibilities:
•
Automatic network configuartion via DHCP
• Manual network configuartion
Automatic network configuration via DHCP:
If the connected network supports DHCP (Dynamic Host Configuration Protocol), all network settings are
8
automatically received from the terminal. It is not necessary to configure the network settings manually.
In a multi-location system a router (DHCP configured) might be installed between the ADSL-modem and the
terminals. A DHCP-router automatically configures all ADSL settings.
Activation of „automatic network configuration via DHCP“:
1. Select „automatic network configuration via DHCP“ (field is marked in yellow)
2. To save settings and exit menu, press Store-Button
3. All network settings are allocated automatically from the DHCP-router / Server
Example of a multi-location system with router (DHCP configured):
The cable from the ADSL modem is connected with the router‘s input socket and the output socket are
linked via Ethernet network cables with the Touch Toy terminals network adapter.
Manual network configuration
The network settings must be configured manually. The connected network does not support DHCP. The
following network addresses are required for a manual configuration (contact the network administrator if
necessary):
• Terminal IP adress
• Subnet Mask
• Default Gateway
• DNS 1, DNS 2
Activation of „Manual network configuration“:
1. Select „Manual network configuration“ (field is marked in yellow)
2. For entering the configuration data press the Editing-Button , type in the configuration data, after all
required data is entered, press Store-Button
2.2.5 Internet connection with LAN
WLAN adapter installation
Connect the WLAN adapter to the blue coloured USB port (modem) of the computer unit. Switch off the
terminal and switch it on again.
Settings for WLAN
• DHCP activated (automatic IP configuration
• Open System
• Supported data encryption: WEP 64/128 Bit, WPA, WPA2
WLAN settings in the network menu
1. Select the available WLAN USB adapter, which is connected to the Touch Toy computer unit
(„Available WLAN adapter“).
2. Select the according WLAN network which the Touch Toy terminal should use to access the internet
(„Available WLAN networks“).
9