6
QUALITY SERIES 2 PUMPS |
OPERATION, INSTALLATION & WARRANTY INFORMATION
3.
Motor humming but not turning
:
IMPORTANT:
SWITCH POWER OFF
-
Possibility of blown capacitor or worn bearings, call a qualified person/s
-
Possible debris in the impeller and/or diffuser causing motor lock
4.
Motor tripping earth leakage:
-
Water inside motor or burned out
-
Damaged cables
5. Motor overheating:
-
Poor ventilation, fan installed too close to wall (minimum of 5cm
unobstructed)
-
Wrong impeller fitted
-
Wrong capacitor fitted
-
Mechanical overload from poor quality bearings or impeller, or diffuser
blocked with grass or other solids
-
Check Ampère (amp) reading against name plate specs
6.
Pump not priming properly:
-
Installed too high above water level of pool (maximum of 300mm above
weir)
-
Sucking air
-
If pump is installed too high above the pool level, fit a spring loaded non return
valve into suction line coming up from underground before entering pump
SPARE PARTS
Please refer to the Quality Pool and Spa website,
www.qualitypoolandspa.co.za
for a detailed spare parts breakdown.
DECLARATION OF CONFORMITY
This product range conforms to the relevant Compulsory Specifications.
WARRANTY
The product must be installed, used and maintained with the care described in
this instruction manual. Any damage caused by non-observation of the safety,
operating and maintenance instructions is the sole responsibility of the user.
This applies in particular to:
-
Incorrect electrical connection (voltage)
-
Inadequately dimensioned power cable
-
Improper use of the product
-
Product modifications not approved by Fluidra
